Wedge Base Size: 0.625
in. Forward
Current (max): 160mA
Total Light
Output: Red (End Lumens/End
Footcandles): 100 Yellow (End Lumens/End
Footcandles): 72 Number of
LEDs:
24
Turn/Running Light for 12/14 Volt
Applications
AUT3157-0UY-014V
$29.50ea
Min.
Qty.
2
Other Voltages†: 24V, 28V, 36V,
48V
YELLOW 595nm
AUT3156 bulbs are keyed
and will not plug into a
3157 socket.
Brake Light for 12/14 Volt
Applications
AUT3156-0ER-014V
$29.50ea
Min.
Qty.
2
Other Voltages†: 24V,
28V, 36V, 48V
RED 633nm
Replacement for: Incandescent
#3156, 3156K, 3456
Wedge Base Size: 0.625
in. Forward
Current (max): (Red, Yellow) 160mA
(White) 120mA
Total Light
Output: Red (End
Lumens / End Footcandles): 100 Yellow (End Lumens/End Footcandles):
72 Cool
White (End Lumens/End
Footcandles): 124 Number of
LEDs:
24
Turn Signal for 12/14 Volt Applications
AUT3156-0UY-014V
$29.50ea Min.
Qty.
2
Other
Voltages†: 24V, 28V, 36V,
48V
YELLOW 595nm
Back-Up Light for 12/14 Volt
Applications AUT3156-0CW-014V
$58.00ea
Min.
Qty.
2
Other
Voltages†: 24V, 28V, 36V,
48V
WHITE 8000K*
* Color temperature in Kelvin
† Custom options
are for qualified applications and large-quantity orders
Sold separately
Load
Resistor AUT-RES-6-50W
$6.48ea
Min.
Qty.
1
Inline Wiring Schematic
Load
Resistor Statement:
If installing LED bulbs in your car or motorcycle causes your
blinkers to blink fast or causes other electrical problems
you may need to install a Load resistor to correct these
problems. Since LED bulbs draw much less current then standard
incandescent bulbs your electrical computer system may think
that your bulbs are not working. The AUT-RES-6-50 should
resolve these problems. This is a 6 Ohms 50 Watt resistor
that needs to be installed in-line with your tail/blinker
lights, one Load resistor (AUT-RES-6-50) is required for
each tail/blinker light.
Caution, this Load resistor (AUT-RES-6-50) gets extremely
hot and needs to be installed correctly. The flat surface
of the AUT-RES-6-50 needs to make a good secure contact
on a clean flat metal surface on your car or motorcycle.
This will act as a heat sink which should keep the Load
resistor (AUT-RES-6-50) cooler. Keep this Load resistor
(AUT-RES-6-50) away from oil, making contact with skin,
plastic, wires and combustible gases and material. LEDtronics
is Not responsible for damage caused to persons or property
with installation of the Load resistor (AUT-RES-6-50).
Applications
Viewing
Angle 25º
Notes 1) For
best results, LED lamp output color should be same as Lens/
Filter color. 2) LED Lamps shown are for most
standard applications. 3) Some applications may require
custom or modified configuration of the LED Lamp. 4) LED
Lamps shown are for direct DC voltage supply. External
resistor, relays or special circuits may require special LED
Lamps.
