| |
Patent Number
US 6,598,996,B1
PDF
Article for LED Auto Bulbs |
|
|
| For aftermarket use. May not comply with SAE or
U.S. DOT standards. |
 |
Note:
LED
brake/tail lamps may not work with some older thermal flasher
units.
An LED brake/tail lamp will require an
electronic flasher/blinker unit which is commonly available
at your local auto parts store.
Designed to work in negative ground vehicles. |
|
Features |
|
Options |
• Easily replaces standard 1157
& 2057 bulb
types
• LED bulbs have greater durability
than
incandescent bulbs
• LED bulbs turn on to full intensity
in
nanoseconds, providing
following drivers 19 extra feet
of stopping distance at 65mph
|
• Low power (Wattage) draw, puts
less load on the
motorcycle
electrical system, like alternator
&
battery.
• LEDs last for 100,000 hours
• Little-or-no heat, always
cool to the
touch
• Three-year lamp warranty
|
|
(for
qualified applications
and large-quantity OEM
orders)
• Other voltages available
• Other bases available
• Other colors available
|
|
Applications |
|
• Stop, taillight, and
license plate lights
• Motorcycles
| |
|
|
|
Load
Resistor Statement:
If installing LED bulbs in your car or motorcycle causes your blinkers to blink
fast or causes other electrical problems you may need to install a Load resistor
to correct these problems. Since LED bulbs draw much less current then standard
incandescent bulbs your electrical computer system may think that your bulbs
are not working. The AUT-RES-6-50 should resolve these problems. This is a
6 Ohms 50 Watt resistor that needs to be installed in-line with your tail/blinker
lights, one Load resistor (AUT-RES-6-50) is required for each tail/blinker
light.
Caution,
this Load resistor (AUT-RES-6-50) gets extremely hot
and needs to be installed correctly. The flat surface
of the AUT-RES-6-50 needs to make a good secure contact
on a clean flat metal surface on your car or motorcycle.
This will act as a heat sink which should keep the Load
resistor (AUT-RES-6-50) cooler. Keep this Load resistor
(AUT-RES-6-50) away from oil, making contact with skin,
plastic, wires and combustible gases and material. LEDtronics
is Not responsible for damage caused to persons
or property with installation of the Load resistor (AUT-RES-6-50). |
|
Special
Notes
1) For best results, LED lamp output color should be
same as Lens/ Filter color above the lamp.
2) LED
Lamps shown are for most standard applications.
3) Some
applications may require custom or modified configuration of
the LED Lamp.
4) LED Lamps shown are for direct DC or AC
voltage supply. External resistor, relays or special circuits
may require special LED
Lamps. |
|
